Cronesix Configuration Software
One program for every Cronesix device. It sets them up over CAN or USB. The software is free and runs on Windows 10 and 11.
Download version 1.4.0 Windows 10 and 11, 71.2 MB, released 2026-09-07
One software for every device
On the left are all Cronesix devices found on the CAN bus. One click opens the device on the right, with everything that can be set on it.
Every device brings its own tabs, the handling stays the same. Once you have set up one device, you know your way around the next.
Every Cronesix control unit with USB is a CAN bus adapter at the same time. One USB cable to one device is enough: the other devices are set up through its CAN bus.
- Plug in the USB cable or an adapter and let it search
- Click the device on the left and connect
- Change settings and save them to the device
The tools one by one
Page editor
Your own display pages with your own images and fonts, as a live editor with the data of the connected wheel. Finished pages can be shared in the community.
See in detail
Logic editor
Functions are drawn instead of programmed. Place blocks on the canvas, connect them with wires, simulate on the PC.
See in detail
Track editor
The final version is still being tested.
Create tracks on the map, from a GPS recording, a file or the roads on the map.
See in detail
CAN bus
All CAN traffic live in one table, your own messages to send and bundled DBC files.
See in detail
Signal plot
Values as curves over time, live from the device at up to 1000 Hz or from a recording.
See in detailWhat else the software does
See signals live
The signal plot shows device values live at up to 1 kHz. On devices with a data logger the recordings can be opened later.
Update firmware
New firmware reaches the device through the software, over the same connection as the settings.
Settings as a file
The whole configuration of a device can be saved, passed on and loaded into another device.
Several devices at once
All devices on the bus are in one window. The signal plot shows values of different devices in one chart.
Manual built in
F1 opens the manual at the place you are working on. Data sheets are included. The software is available in German and English.
Connect your own AI program
Claude or Codex read the running software, build logic and change the device only after asking.
Trying it costs nothing
The software is free and runs without a connected device. Every device can be opened and viewed offline.